9710 (StorageTek) Addendum for NonStop Servers

Addendum to the StorageTek 9710 for the Tandem Environment
Configuring the Compaq System for the 9710 Automated Cartridge Subsystem
6-2
6.2 Completing the MFC RS-232/SCSI BIC Diagram
To house a DLT cartridge tape subsystem in the 9710 ASC Tape
Cartridge Subsystem to be attached to an MFC, document the
installation using an MFC RS-232/SCSI BIC Diagram. Figure 6-1
shows an example of a completed diagram.
For more information about completing BIC diagrams or
configuring controllers, refer to Configuring Controllers for
NonStop Systems.
Note. Only one tape drive can be attached to an MFC. Not more
than one tape drive can be configured on the same MFC. The
SCSI ID for a tape drive attached to the MFC is 5.
To complete the BIC diagram, first make a photocopy of the form
for each MFC to be used as a T16/5155/5159 tape controller. Then
complete the entries as described in the following paragraphs. (You
are authorized to photocopy forms only for the purpose of installing
and configuring the Tandem NonStop System.)
6.2.1 Identify the System, Cabinet Number, and Section Number
In the upper right corner of the form, enter the system name on the
System Name line and the cabinet number on the Cabinet Number
line. If applicable, enter the section number on the Section Number
line.