9710 (StorageTek) Addendum for NonStop Servers

Addendum to the StorageTek 9710 for the Tandem Environment
Configuring the Compaq System for the 9710 Automated Cartridge Subsystem
6-7
6.2.4 J1, J2, J3, and J4 Connectors
The remaining connectors are used for modems, communications
lines, terminals, and printers. For detailed instructions about how
to complete these parts of the form, refer to Configuring
Controllers for NonStop Systems (Compaq Part #111154).
6.2.5 Date the Form
When this form is completed, enter today’s date on the Date line.
6.3 Completing the 3216 Controller BIC Diagram
To attach the T16/5155/5159 DLTtape Drive FRU to a 3216
controller, document the installation using a 3216 Controller BIC
Diagram. The following paragraphs contain the detailed procedure,
including considerations and valid entries, for completing the 3216
Controller BIC Diagram. Figure 6-2
shows an example of a completed diagram.
To complete the BIC diagram, first make a photocopy of the form
for each 3216 controller controlling a T16/5155/5159 DLTtape
Drive FRU. Then fill in the form as described in the following
paragraphs. (You are authorized to photocopy forms only for the
purpose of installing and configuring the Tandem NonStop system.)
6.3.1 Identify the System and the Controller
In the upper right corner of the form, enter the name of the system
on the System Name line and the cabinet and section number, as
appropriate. Then complete the identification lines at the top of the
form:
• Enter the logical device name of the controller on the Controller
Name line.