AM3270 and TR3271 Configuration and Management Manual

SCF Interface to AM3270 and TR3271
AM3270 and TR3271 Configuration and Management Manual—529993-001
4-77
STATUS Command
STATUS Command
The STATUS command displays status information about an object, such as the
dynamic summary state, the last error, and modifiable values of the specified object.
It also displays specific subsystem attributes and values.
Considerations for the STATUS Command
•
Wild cards are not supported at the subdevice level.
•
If the SEL option is specified, object-type can be LINE or SU.
Command Syntax for the STATUS Command
The STATUS command has the following syntax:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
LINE line-name | SU su-name
designates the line or subdevice whose status information is to be displayed.
If you omit line-name or su-name, the status of the assumed object is
displayed.
DETAIL
if present, returns complete status information. If you omit DETAIL, only a single
line of data is displayed for each object name.
SUB [ ONLY | ALL | NONE ]
directs the command at a set of subordinate objects.
ONLY specifies that only the subordinate objects are affected.
ALL specifies that the named object and the subordinate objects are affected.
NONE specifies that none of the subordinate objects are affected.
If you omit subtype, ALL is assumed.
STATUS [ / OUT file-spec / ] [ LINE line-name | SU su-name ]
[ , DETAIL ] [ , SUB [ ONLY | ALL | NONE ] ]
[ , SEL [ STARTED | STOPPED ] ]