AM3270 and TR3271 Configuration and Management Manual

Moving to G-Series Systems
AM3270 and TR3271 Configuration and Management Manual—529993-001
A-2
CONFTEXT Paragraph Information
CONFTEXT Paragraph Information
Table A-1 lists the CONFTEXT paragraphs that are relevant to AM3270/TR3271
configuration and how the information in each paragraph is defined on G-series
systems.
For more information about NonStop Kernel subsystem configuration, see the SCF
Reference Manual for the Kernel Subsystem.
COUP-to-SCF Considerations
The COUP interface is no longer supported for G-series releases. COUP functionality
is replaced by SCF. Although most COUP commands have a direct SCF equivalent,
the method of configuration on G-series systems is very different from D-series
systems. Refer to the SCF reference manuals listed in “About This Manual” for more
information.
The following COUP commands have no SCF equivalent and cannot be used with G-
series systems:
Table A-1. Defining CONFTEXT Paragraph Information on G-Series Systems
CONFTEXT Paragraph G-Series Definition
DEFINES Customizes a profile to be used later when configuring
a DEVICE object type
CONTROLLERS Concentrator information is configured through the
WAN subsystem
PATHS Not applicable for G-series systems
PERIPHERALS IOPs are configured through the WAN subsystem
ALLPROCESSORS Still exists in G-series CONFTEXT file
CONFIG
INFO CONTROLLER
INFO
MF_CONTROLLERS
INFO PATH
RESET
SHOW
TIME