AM3270 and TR3271 Configuration and Management Manual

Error Messages for AM3270
AM3270 and TR3271 Configuration and Management Manual—529993-001
D-4
Message Descriptions
Cause. There is no object in the selected summary state. This usually happens on a
STATUS LINE, SUB ONLY, SEL state command.
Effect. Command could not be completed.
Recovery. None. This error can be considered an informational message.
00008
Cause. A STOP command has been issued for the line, but there are SUs which are
currently opened by applications.
Effect. Command could not be completed.
Recovery. Close all SUs before stopping the line.
00009
Cause. All commands will be rejected if Debug is ON.
Effect. Command could not be completed.
Recovery. None. This error can be considered as informational.
00010
Cause. The specified target object name is an invalid object name.
Effect. Command could not be completed.
Recovery. Check the format of the target object name, make any corrections, and try
the command again.
00011
Cause. An ownership error has occurred on an I/O operation. This usually means that
the preferred TCP/IP is either not present or LAN controller ownership has switched to
another CPU.
Effect. Command could not be completed.
Recovery. Correct any configuration or operational problems and re-issue the
command.
AM3270 00008 Opened SUs exist.
AM3270 00009 SU not connected to the Target SU..
AM3270 00010 Invalid target object name.
AM3270 00011 No owner.