AM3270 and TR3271 Configuration and Management Manual

Error Messages for AM3270
AM3270 and TR3271 Configuration and Management Manual—529993-001
D-6
Message Descriptions
00503
Cause. Not enough characters were specified for the XLATEIN and XLATEOUT
attributes. See Section 6, Attribute Descriptions for AM3270 and TR3271 for
information about the XLATEIN and XLATEOUT attributes.
Effect. Command could not be completed.
Recovery. Make sure that 256 characters have been specified.
00506
Cause. An invalid value was received for the object name in an ALTER command.
The first wild card shows the attribute. For example, PACE or TRANSLATE. The
second wild card shows the object name. For example, $AM32S1. If you entered the
command ALTER LINE $AM32S1...TRANSLATE 2, and SCF required an On or an Off,
you would receive this error.
Effect. Command could not be completed.
Recovery. Check the value and reissue the command.
00508
Cause. Not expecting '' , '' after the delete command name.
Effect. Command could not be completed.
Recovery. Check the value and reissue the command.
00509
Cause. The CPU specified in the ALTER command is not valid.
Effect. Command could not be completed.
Recovery. Correct the CPU value in the command and reissue the command. The
CPU value should be in the range of 0-15 inclusive.
00510
Cause. The user tried to alter the line to a path already being used.
AM3270 00503 Less than 256 characters specified.
AM3270 00506 Invalid Value: \* for \*
AM3270 00508 Invalid command format. Not expecting char '' , ''.
AM3270 00509 Recource CPU not configured.
AM3270 00510 Already using CPU/PATH/ADDRESS.