AM3270 and TR3271 Configuration and Management Manual

Error Messages for TR3271
AM3270 and TR3271 Configuration and Management Manual—529993-001
E-3
Message Descriptions
Cause. One or more of the specified line attributes conflicts with a transparent SU.
This usually happens on an ALTER LINE command. In order to have a transparent SU,
the line must be configured as follows:
CHARACTERSET = EBCDIC
CONTROLSET = EBCDIC
TRANSLATE = ON
TRANSPARENT = ON
An attempt was made to change one of these attributes.
Effect. Command could not be completed.
Recovery. Do not change any of the attributes listed above.
00005
Cause. The operation failed because the SU protocol is not PTP. This usually
happens on a CONNECT or DISCONNECT command.
Effect. Operation failed.
Recovery. Specify a PTP TR3271 SU or a PTP AM3270 SU.
00006
Cause. The address specified in an ADD command has already been defined for
another subdevice.
Effect. Command could not be completed.
Recovery. Use another address.
00007
Cause. There is no object in the selected summary state. This usually happens on a
STATUS LINE, SUB ONLY, SEL state command.
Effect. Command could not be completed.
Recovery. None. This error can be considered an informational message.
00008
TR3271 00005 Not a PTP SU.
TR3271 00006 Address already taken.
TR3271 00007 No object is in the selected state.
TR3271 00008 Opened SUs exist.