AM3270 and TR3271 Configuration and Management Manual

SCF Interface to AM3270 and TR3271
AM3270 and TR3271 Configuration and Management Manual—529993-001
4-38
Command Syntax for the STATUS Command
Command Syntax for the STATUS Command
The STATUS command has the following syntax:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
LINE line-name | SU su-name
designates the line or subdevice whose status information is to be displayed.
If you omit line-name or su-name, the status of the assumed object is
displayed.
DETAIL
if present, returns complete status information. If you omit DETAIL, only a single
line of data is displayed for each object name.
SUB [ ONLY | ALL | NONE ]
•
Directs the command at a set of subordinate objects.
•
ONLY specifies that only the subordinate objects are affected.
•
ALL specifies that the named object and the subordinate objects are affected.
•
NONE specifies that no subordinate objects are affected.
•
If you omit subtype, ALL is assumed.
SEL [ STARTED | STOPPED ]
directs the command only at objects in the specified state. Valid states are
STARTED and STOPPED.
STATUS [ / OUT file-spec / ] [ LINE line-name | SU su-name ]
[ , DETAIL ] [ , SUB [ ONLY | ALL | NONE ] ]
[ , SEL [ STARTED | STOPPED ] ]