AM3270 and TR3271 Configuration and Management Manual

SCF Interface to AM3270 and TR3271
AM3270 and TR3271 Configuration and Management Manual—529993-001
4-42
Display for the STATUS SU Command
The display for an SU object with the DETAIL option has the following format:
Name
is the name of the AM3270-queried subdevice.
State
is the current summary state of the queried subdevice.
Status
is the status word that contains status information for the subdevices that have
been queried. See Appendix G, 3174 Device Status/Sense Bytes for information
about the status word.
LastError
is the last error detected on the queried subdevice.
Flags
is a bit array that indicates status information for the subdevice. The status can be
a combination of these bits. The bits, when set to on, are:
AM3270 Detailed Status SU
Name............. $AM3270.#TERM1 State............. STARTED
Status........... %0000000 LastError......... 0
Flags............ %0000000 SDN............... 1
Bit Meaning
0 READ request is pending.
1 WRITE request is pending.
2 WRITEREAD request is pending.
3 Not used.
4 Subdevice is waiting for a buffer.
5 Subdevice is busy.
6 Internal use only.
7 Two-step READ is pending.
8 Subdevice is waiting for a real READ.
9 Internal use only.
10 Subsystem is attempting to connect the subdevice. This bit applies
to PTP subdevices only.
11 Subsystem is attempting to disconnect the subdevice. This bit
applies to PTP subdevices only.
12 Not used.