AM3270 Management Programming Manual

COMMANDS AND RESPONSES

LOAD Command

The LOAD command causes the specified software to be downloaded

to the Communications Line Interface Processor (CLIP). You can

only specify the LINE object in the LOAD command.

When your management application issues the LOAD command, the

line must be in the STOPPED summary state and must not already

be loaded. Once the command is completed and the CLIP is loaded,

start the CLIP.

Typically, a RESET must be performed prior to issuing the LOAD

command. However, if the NOLOAD modifier has been specified at

system generation time, the line comes up not loaded, and the

subsystem can accept the LOAD command without previously being

RESET.

Command

ZCOM-CMD-LOAD

Object Type

ZCOM-OBJ-LINE

Tokens in Command Buffer

ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING. !{}

ZCOM-MAP-REQID !MAP is optional, but if present,

!fields are required.

def ZCOM-DDL-REQID.

02 ZCRTPID type ZSPI-DDL-CRTPID.

02 ZPAID type ZSPI-DDL-INT.

end.

ZCOM-TKN-CMD-TIMEOUT token-type ZSPI-TYP-TIMESTAMP.

ZSPI-TKN-MANAGER token-type ZSPI-TYP-FNAME32.

ZSPI-TKN-SSID token-type ZSPI-TYP-SSID. !{}

ZSPI-TKN-MAXRESP token-type ZSPI-TYP-INT.

ZSPI-TKN-CONTEXT token-type ZSPI-TYP-BYTESTRING.

ZSPI-TKN-RESPONSE-TYPE token-type ZSPI-TYP-ENUM.

ZSPI-TKN-ALLOW-TYPE token-type ZSPI-TYP-ENUM.

ZSPI-TKN-COMMENT token-type ZSPI-TYP-STRING.

6-69