AM3270 Management Programming Manual

COMMANDS AND RESPONSES
LOAD Command
The possible nonzero values of RETCODE in response to the LOAD
command are as follows:
ZCOM-ERR-EMPT-RSP (-33)
ZCOM-ERR-TKN-VAL-INV (-30)
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-OBJNAME-INV (-19)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-FNAME-INV (-9)
ZCOM-ERR-CMD-TIMED-OUT (-7)
ZCOM-ERR-CMD-MISMATCH (-4)
ZCOM-ERR-CMD-INV-IN-SUMSTATE (-3)
Your management application tried to load a line that was not
in the STOPPED summary state. The line cannot be in the
STARTED or DIAG (diagnosing) summary state when this command
is issued.
ZSPI-TKN-ENDLIST indicates the end of a data list or an error
list. See "SPI Standard Definitions" in Section 5 for details.
Operational Notes
• LOAD is a sensitive command.
• When the command is completed, the line remains in the STOPPED
summary state.
• The line must be in the STOPPED summary state when this
command is issued.
• Use the START command to start the line.
• The RESET command should be issued before the LOAD command,
unless the NOLOAD modifier has been specified at system
generation time.
6-72