AM3270 Management Programming Manual

COMMANDS AND RESPONSES
RESET Command
ZCOM-ERR-CMD-MISMATCH (-4)
Your management application tried to reset a process by using
the value ZCOM-OBJ-PROC or a subdevice by using the value
ZCOM-OBJ-SU. The command is valid only for the value ZCOM-
OBJ-LINE (LINE object).
ZCOM-ERR-CMD-INV-IN-SUMSTATE (-3)
Your management application tried to reset a line that was
not in the STOPPED summary state. The STARTED and DIAG
(diagnosing) summary states prevent processing of the RESET
command.
ZSPI-TKN-ENDLIST indicates the end of a data list or an error
list. See "SPI Standard Definitions" in Section 5 for details.
Operational Notes
• RESET is a sensitive command.
• The line must be in the STOPPED summary state when this
command is issued.
• When the command is completed, the line remains in the STOPPED
summary state.
• This command should always be issued before the LOAD command,
unless the NOLOAD modifier has been specified at system
generation time.
6-76