AM3270 Management Programming Manual

COMMANDS AND RESPONSES
RESETSTATS Command
ZCOM-TKN-OBJTYPE specifies the type of object for which informa-
tion was requested. This token can have the value ZCOM-OBJ-
LINE (LINE object) or ZCOM-OBJ-SU (SU object). This token
is described in "Data-Communications Standard Definitions" in
Section 5, "Common Definitions," and the Communications
Management Programming Manual .
ZSPI-TKN-ERRLIST indicates the beginning of an error list. See
"SPI Standard Definitions" in Section 5 for details.
ZSPI-TKN-RETCODE specifies the return code for the command. This
token is described in "SPI Standard Definitions" in Section 5
and the Distributed Systems Management (DSM) Programming Manual .
For details on the data-communications error numbers and their
associated error lists, see "Common Error Numbers and Error
Lists" in the Communications Management Programming Manual .
The possible nonzero values of RETCODE in response to the
RESETSTATS command are as follows:
ZCOM-ERR-EMPT-RSP (-33)
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SUB-NOT-FOUND (-25)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-OBJNAME-INV (-19)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-FNAME-INV (-9)
ZCOM-ERR-CMD-TIMED-OUT (-7)
ZCOM-ERR-TKN-VAL-INV (-30)
Your management application specified the SUB modifier with
the value ZCOM-VAL-SUB-ONLY or ZCOM-VAL-SUB-ALL for the SU
object. The SU object accepts only the value ZCOM-VAL-SUB-
NONE.
ZCOM-ERR-CMD-MISMATCH (-4)
Your management application tried to obtain statistical infor-
mation for a process by using the value ZCOM-OBJ-PROC. The
command is valid only for the values ZCOM-OBJ-LINE (LINE
object) or ZCOM-OBJ-SU (SU object).
6-83