AM3270 Management Programming Manual

EVENT MANAGEMENT
147: ZAM3-EVT-CSS-PROBE-ERR
ZAM3-TKN-PROBE-ERR is the type of probe error. It corresponds
to the value probe-err in the message text. See below for
information on the possible values.
For details on any of the EMS tokens, refer to the Event
Management Service (EMS) Manual .
Volatile Tokens
ZEMS-TKN-CU is a standard EMS token that contains the controller
and unit number. This token is present in the event buffer only
if the controller uses subchannel-type I/O addressing.
Event-Message Text
In the text message, ldev corresponds to the value of ZEMS-
TKN-LDEV, n,n,%nn,%nnn corresponds to the value of ZEMS-MAP-
EXIOADDR, ldevname corresponds to the value of ZEMS-TKN-LDEVNAME,
path corresponds to the value of ZCOM-TKN-NEW-PATH, and probe-err
corresponds to the value of ZAM3-TKN-PROBE-ERR,
Probable Cause
The AM3270 IOP received no status probe from the CLIP indicating
that it is in the boot state instead of the run state. The
AM3270 subsystem attempts to download the CLIP again. If this
cannot be done on the primary path, AM3270 attempts a download on
another path. The value path indicates the primary path. The
possible values are ZCOM-VAL-PATH-A and ZCOM-VAL-PATH-B.
The value probe-err in the text message contains the CLIP status
byte. The possible values are as follows:
Value Meaning
-1 no response--timed out
-2 unexpected probe status
1 CLB type--normal frame
2 CLB type--first frame
3 CLB type--continue
4 CLB type--last frame
5 CLB type--abort
6 CLB type--error
7-42