AM3270 Management Programming Manual

ERROR NUMBERS AND ERROR LISTS

2: ZAM3-ERR-CLIP-PROB

The command failed because of an internal CLIP problem. When

this error occurs, the AM3270 subsystem sends event message 164

or 165 to the EMS collector, $0.

ZSPI-TKN-ERRLIST type ZSPI-TYP-LIST

ZSPI-TKN-ERROR type ZSPI-TYP-ERROR

ZCOM-TKN-OBJNAME type ZSPI-TYP-STRING

ZCOM-TKN-OBJTYPE type ZSPI-TYP-ENUM

ZSPI-TKN-ENDLIST type ZSPI-TYP-SSCTL

Tokens

ZSPI-TKN-ERROR is the standard SPI error token described in the

Distributed Systems Management (DSM) Programming Manual

. Its

value consists of the target subsystem ID and the error number

ZAM3-ERR-CLIP-PROB. This token is always present in the error

list.

ZCOM-TKN-OBJNAME is the object name on which the error occurred

in the command. This token is present in the error list if its

presence is relevant to the cause of the error. That is, if the

error was detected after the subsystem made choices based on the

object name, this token is present in the error list. Otherwise,

it is omitted from the list.

ZCOM-TKN-OBJTYPE is the object type provided with the command on

which the error occurred. Its value defines the type of object

against which the command was issued.

Recommended Action

Check for event message 164 or 165. The event message lists the

error, CLIP function modifier, and the CLIP status. Note these

values and contact your Tandem representative.

A-3