AM3270 Management Programming Manual

COMMANDS AND RESPONSES
ALTER Command
ZSPI-TKN-RETCODE specifies the return code for the command. This
token is described in "SPI Standard Definitions" in Section 5 and
the Distributed Systems Management (DSM) Programming Manual .
For details on the data-communications error numbers and their
associated error lists, see "Common Error Numbers and Error
Lists" in the Communications Management Programming Manual . For
details on the AM3270 error number and their associated error
lists, see Appendix A in this manual.
The possible nonzero values of RETCODE in response to the ALTER
command are as follows:
ZCOM-ERR-VAL-REQ (-31)
ZCOM-ERR-TKN-VAL-INV (-30)
ZCOM-ERR-TKN-LEN-INV (-28)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-OBJNAME-INV (-19)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-FNAME-INV (-9)
ZCOM-ERR-CMD-TIMED-OUT (-7)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
Your management application has tried to alter an object that
is not supported by the AM3270 subsystem. The supported
objects are PROC, LINE and SU. For the ALTER command, you
must specify the value ZCOM-OBJ-LINE (LINE object) or ZCOM-
OBJ-SU (SU object).
ZCOM-ERR-NO-MEM-SPACE (-14)
The subsystem cannot alter the subdevice at this time because
the necessary memory for the line or subdevice control block
cannot be allocated.
ZCOM-ERR-CMD-MISMATCH (-4)
Your management application tried to alter a process by using
the value ZCOM-OBJ-PROC. The command is valid only for the
value ZCOM-OBJ-LINE or ZCOM-OBJ-SU.
ZCOM-ERR-CMD-INV-IN-SUMSTATE (-3)
Your management application tried to alter a line or subdevice
while the line was in the DIAG summary state. This summary
state prevents processing of the ALTER command.
6-30