ASAP 1.1 Hybrid Manual

HP NonStop ASAP Hybrid Manual – 529729-004
Page 3-14
SampleInterval
Description: Interval, in seconds, at which the server sends data to NonStop
ASAP. If HTMLStatus is set to True, domain status data is also written at this
interval to the asapdomains.html file. The SampleInterval value should not
exceed the smallest ASAP RATE value among all the ASAP environments
into which applications on the Linux system are registered. For example,
assume that some of the domains on the Linux system are registered into
the ASAP environment $ZOO and that $ZOO has been configured with a
RATE of 4 minutes. Assume also that the remainder of the domains on the
Linux system are registered into the environment $ZAS and that $ZAS has
been configured with a RATE of 1 minute. In this case, the SampleInterval
should be configured to be 60 seconds or less because the lowest RATE
value in the two ASAP environments is 1 minute (from $ZAS).
Value Range: 0 through 2147483647
Default Value: 60
Example: SampleInterval = 120
Tracing Options
Tracing configuration options are contained in the Tracing section of the
configuration file. These options define what data is traced, where trace
data is written, and how much data is captured and retained. Each option is
described in detail below.
Enabled
Description: True if tracing is enabled and False if tracing is disabled.
Tracing is disabled by default and should remain disabled unless you are
trying to diagnose a problem. In that case, contact HP support so that they
can advise you how to best define trace parameters to capture information
on the problem you are encountering.
Value Range: True or False
Default Value: False