ASAP 2.8 Messages Manual

HP NonStop ASAP Messages Manual—429917-004
1-110
4395
processing
processing area for elapsed time
num
the amount of elapsed time, in milliseconds, the specified processing took. This is
the elapsed time during processing, not the time the processing itself took.
Cause. The Spooler parameter STATS was set when the Spooler SGP was started.
Therefore, this message indicates how much time elapsed during the indicated
processing.
Effect. None.
Recovery. Informational message; no corrective action is necessary. To stop these
messages from appearing, remove the STATS parameter from the ASAPCONF file or
reset it from your ASAP session, then restart the Spooler SGP.
4396
Cause. An error occurred when trying to load the spooler domain names to monitor
(see 4302 on page 1-103). This message indicates that the last list of domains will be
used instead.
Effect. The previous spooler configuration is reloaded, and the last list of domains is
used.
Recovery. Informational message; no corrective action is necessary. However,
because this message appears after error 4302 on page 1-103, see the recovery for
that message to fix the problem it indicates.
4397
num
maximum number of spooler domains to monitor previously set in ASAP.
Cause. The maximum number of spooler domains to monitor was reached.
Effect. The overflow spooler domains are not monitored.
SPL Sampling delay processing: num
SPL Reloading previous configuration.
SPL Could not load all domains: maximum of num reached.