ASAP 2.8 Messages Manual

HP NonStop ASAP Messages Manual—429917-004
2-106
ZASP-TKN-ASAP-ERRORNUM is “2035”.
2036: ZASP-EVT-COL-CTL-PARSE-ERROR
parse-error
is the text of the parsing error, which describes the error.
num-chars
is the offset within the line that caused the error.
Cause. The Collector encountered an error while parsing partitioning settings read
from the partition control file due to illegal data in the file. The file might be corrupt or
invalid.
Effect. The Collector logs the error and continues to process the control file. If the
entire file is corrupt or invalid, the database is created using default settings. If some
entries in the file are good, they are used to create the database.
Recovery. Shut down and restart the Collector to re-create the partition control file.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is “2036”.
2037: ZASP-EVT-COL-CTL-WRITE-ERROR
error
is the file-system error number. If greater than 0, it indicates the encountered file-
system error. If less than 0, it indicates an internal ASAP error.
Cause. The Collector could not write status information to the partition control file after
reading the file. The cause is most likely a security violation.
Effect. The Collector logs the error and continues to run normally. Status information
is not written to the control file, but Collector operations are not otherwise affected.
Recovery. Depends on error. If an internal ASAP error occurred, contact your
support representative.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is “2037”.
parse-error num-chars
Collector could not write partition ctl file error