ASAP 2.8 Messages Manual

HP NonStop ASAP Messages Manual—429917-004
2-132
4396: ZASP-EVT-SPL-RELOADPREV-INF
Cause. An error occurred when trying to load the spooler domain names to monitor
(see 4302: ZASP-EVT-SPL-READDOM-ERR on page 2-122). This message indicates
that the last list of domains will be used instead.
Effect. The previous spooler configuration is reloaded, and the last list of domains is
used.
Recovery. Informational message; no corrective action is necessary. However,
because this message appears after error 4302: ZASP-EVT-SPL-READDOM-ERR on
page 2-122, see the recovery for that message to fix the problem it indicates.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is “4396”.
4397: ZASP-EVT-SPL-DOMAINOVR-INF
num
is the maximum number of spooler domains to monitor previously set in ASAP.
Cause. The maximum number of spooler domains to monitor was reached.
Effect. The overflow spooler domains are not monitored.
Recovery. Monitor fewer spooler domains. If this becomes a significant issue, contact
your HP support representative.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is “4397”.
4398: ZASP-EVT-SPL-AUTOCONFIG-INF
Cause. No spooler domains are specified in the objective database; therefore, the
Spooler SGP has autoconfigured to monitor the $SPLS spooler.
Effect. The Spooler is configured to monitor only the $SPLS spooler.
Recovery. Informational message; no corrective action is necessary.
SPL Reloading previous configuration.
SPL Could not load all domains: maximum of num reached.
SPL Autoconfiguration completed.