ASAP 2.8 Messages Manual

HP NonStop ASAP Messages Manual—429917-004
2-142
num
elapsed time spent in the processing area
Cause. The Tape parameter STATS was set when the Tape SGP was started. This
message indicates how many milliseconds elapsed (not how much time processing
took) when doing the indicated processing.
Effect. None.
Recovery. Informational message; no corrective action is necessary. To eliminate
these messages from appearing, remove the STATS parameter from the ASAPCONF
file or reset it from your ASAP session, and restart the Tape SGP.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is “4495”.
4496: ZASP-EVT-TAP-RELOADPREV-INF
Cause. An error occurred when trying to load the tape domain names to be monitored
(see message 4402: ZASP-EVT-TAP-READDOM-ERR on page 2-133). This message
indicates that the last list of domains is used instead.
Effect. None.
Recovery. Informational message. See recovery for message 4402: ZASP-EVT-TAP-
READDOM-ERR on page 2-133.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is “4496”.
4497: ZASP-EVT-TAP-DOMAINOVR-INF
num
maximum number of tape domain entries allowed in the Tape SGP
Cause. The maximum number of tape domains to be monitored was reached.
Effect. The overflow tape domains are not monitored.
Recovery. Monitor fewer tape domains. If this becomes an issue, contact your support
representative and describe your requirements.
TAP Reloading previous configuration.
TAP Could not load all domains: maximum of num reached.