ASAP 2.8 Messages Manual

HP NonStop ASAP Messages Manual—429917-004
2-174
Recovery. Stop and delete the measurement named ZCMMxxx, where xxx is the
ASAP ID. Use the Measure interface MEASCOM.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is "4747".
4748: ZASP-EVT-CMM-SHUTDWN-COMPLETE
Cause. ASAPCMM was stopped by the ASAPMON process.
Effect. ASAPCMM stops its measurement.
Recovery. Informational message only; no corrective action is needed.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is "4748".
4750: ZASP-EVT-CMM-PARAM-ERROR
param
contains the parameter that caused the problem.
Cause. ASAPCMM detected an invalid parameter in the SET COMM
ON,PARAMETER command.
Effect. ASAPCMM used the default values for all parameters.
Recovery. Ensure that all parameters contained in the ASAP startup file ASAPCONF
are valid, then restart the ASAP Monitor.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is "4750".
ASAPCMM Disk Measurement stopped
Error SET Comm PARAM param