ASAP 2.8 Messages Manual

HP NonStop ASAP Messages Manual—429917-004
1-61
Recovery. Specify a valid disk volume using the ASAP command SET DISK,PARAM
“Volume<$vol>.
1742
Cause. The Disk SGP could not access the device control table. ldev represents the
logical number of the device.
Effect. ASAPDSK cannot collect disk statistics.
Recovery. Contact your HP representative.
1743
Cause. ASAPDSK could not restart its measurement. err represents the Measure
error returned from the Measure subsystem.
Effect. ASAPDSK could not obtain disk counters during a sample interval. Disk
statistics are set to null for the sample interval when ASAPDSK cannot get DP2
counters.
Recovery. Check the ASAP log for previous ASAPDSK messages and make the
appropriate corrections. For corrective action for the specified error, see Appendix B of
the Measure Reference Manual.
1744
Cause. The Disk SGP could not access the device. ldev represents the logical
number of the device. ctrl represents the controller number in decimal.
Effect. ASAPDSK cannot collect disk counters. Disk device status information is valid
when ASAPDSK cannot obtain the disk counters.
Recovery. Contact your HP representative.
1745
Cause. The Disk SGP will not collect statistics on configured optical disk devices.
Effect. ASAPDSK will not report optical disk statistics.
ASAPDSK DCT access error ldev
ASAPDSK cannot restart measurement.err
ASAPDSK Disk device inaccessible ldev, ctrl
ASAPDSK Optical Disk statistics not collected