ASAP 2.8 Server Manual

ASAP Conversational Interface Commands

HP NonStop ASAP Server Manual—522303-007

6-26

DISK Command

where the ASAP program was started, or the system specified in the ASAP

SYSTEM command.

volume

specifies the individual DISK volume for which performance and state information

is to be displayed. All the disks from all the collected nodes can be output by

specifying DISK \*.*. If you do not specify a DISK or the wild-card character (*), the

default is used. The default is all the DISK devices on the current system.

specifies that the performance and state information for all disks on the specified

system is displayed. If you do not specify a disk volume or the wild-card character

(*), statistics for all disks on the current system are displayed.

SAMPLES count

specifies the number of sample periods to be displayed. A sample period is defined

by the RATE option in the SET command. You can specify 0 through 255 sample

periods. The default sample period number is 1.

TIME hh:mm m/d/y

defines the ending time of the display information in hours, minutes, month, day,

and year. For example, specifying “TIME 10:15” when RATE is 5 indicates that

statistics collected from 10:10 to 10:15 are displayed.

When a “?” appears immediately after the timestamp, it indicates that the statistics

are questionable and that there was a problem obtaining the statistics. Possible

reasons for questionable statistics include:

•

Down Disk Drives or down volume

•

Disk being revived, formatted, or mounted

When a “<” appears immediately after the timestamp, the statistics were received

late by the Collector process. Late statistics indicate busy Expand lines.

is the hour.

is the minute.

m/d/y

is the month, day, and year. Valid m/d/y entries are mm/dd/yy, yyyy/mm/dd,

or mm/dd/yyyy.