ASAP 2.8 Server Manual

ASAP Conversational Interface Commands
HP NonStop ASAP Server Manual—522303-007
6-47
LH Command
*
specifies that availability information for all lines is to be displayed. If you do not
specify a line or the wild-card character (*), ASAP uses the default, which is all
Expand lines for the current system.
INFO
displays line attribute information. The information includes the logical device
number (LDEV), the primary and backup processor identifiers, the line subtype, the
NEXTSYS and time factor values, and any ASAP line collection errors.
FRAMES
displays Level 2 information/supervisory (I/S) frames sent and received and I/S
frame ratios. Level 2, the link layer, is the communications interface to the
controller defined by the line type.
I
represents the information frames.
S
represents the supervisory frames.
U
represents the unnumbered (nonsequenced) frames.
For Expand-over-IP and Expand-over-ATM Level 2 i/s frames have these
meanings:
•
IFrm(S/R) displays number of Data Frames sent and received.
•
SFrm(S/R) displays number of Connect Commands sent and rcvd.
•
UFrm(S/R) displays number of Connect Responses sent and rcvd.
For Expand over SERVERNET Level 2 i/s frames have these meanings:
•
IFrm(S/R) displays number of Data Frames sent and received.
•
SFrm(S/R) displays number of Active Connect Cmnds sent & rcvd.
•
UFrm(S/R) displays number of Passive Connects sent & rcvd.
HISTO
displays a histogram of the message size distribution. The histogram provides
information about message sizes less than the values of 64, 128, 256, 512, 1024,
2048, and 4096.