ASAP 2.8 Server Manual

ASAP Conversational Interface Commands

HP NonStop ASAP Server Manual—522303-007

6-127

SPOOLER Command

SAMPLES count

specifies the number of sample periods to be displayed. A sample period is defined

by the RATE option in the SET command. You can specify 0 through 255 sample

periods. The default sample period number is 1.

TIME hh:mm m/d/y

defines the ending time of the display information in hours, minutes, month, day,

and year. For example, specifying “TIME 10:15” when RATE is 5 indicates that

statistics collected from 10:10 to 10:15 are to be displayed.

When a “?” appears immediately after the timestamp, it indicates that the statistics

are questionable and that there was a problem obtaining the statistics. Possible

reasons for questionable statistics include:

Down disk drive or down volume

Disk is being revived, formatted, or mounted

When a “<” appears immediately after the timestamp, the statistics were received

late by the Collector process. Late statistics indicate busy Expand lines.

is the hour.

is the minute.

m/d/y

is the month, day, and year. Valid m/d/y entries are mm/dd/yy, yyyy/mm/dd,

or mm/dd/yyyy.

STATES

shows states associated to spooler attributes.

DETAIL

shows detailed information for the specified spooler domain (supervisor, collector,

device, print process). The specified domain name indicates which type of

information is returned (see Examples on page 6-128).

Use this display only if your spooler configuration is not too large, or if you specify

only certain spooler components using the EXACT option.

SHORT

when used with DETAIL or MINSTATE, displays information in short form.