ASAP 3.0 Messages Manual

HP NonStop Messages Manual Page 129 of 407
configuration is correct, note the name, create a saveabend file of the Spooler SGP,
stop the SGP, and contact your HP support representative.
4393
Timeout error occurred in get^spooler^stats for SGP SPL.
Cause. The spooler supervisor was too busy to return information to the SPL SGP.
Effect. The Spooler SGP tries five times, in one second intervals, before giving up.
Recovery. If this error occurs frequently, check why the spooler supervisor is so busy.
4394
SPL EDL loaded.
Cause. The Spooler EDL loaded correctly on startup of ASAP.
Effect. The Spooler SGP runs normally.
Recovery. Informational message; no corrective action is necessary.
4395
SPL Sampling delay processing: num
processing
processing area for elapsed time
num
the amount of elapsed time, in milliseconds, the specified processing took. This is
the elapsed time during processing, not the time the processing itself took.
Cause. The Spooler parameter STATS was set when the Spooler SGP was started.
Therefore, this message indicates how much time elapsed during the indicated
processing.
Effect. None.
Recovery. Informational message; no corrective action is necessary. To stop these
messages from appearing, remove the STATS parameter from the ASAPCONF file or
reset it from your ASAP session, then restart the Spooler SGP.
4396
SPL Reloading previous configuration.