ASAP 3.0 Messages Manual

HP NonStop Messages Manual Page 130 of 407
Cause. An error occurred when trying to load the spooler domain names to monitor
(see message 4302 on page 123). This message indicates that the last list of domains
will be used instead.
Effect. The previous spooler configuration is reloaded, and the last list of domains is
used.
Recovery. Informational message; no corrective action is necessary. However,
because this message appears after error 4302 on page 123, see the recovery for that
message to fix the problem it indicates.
4397
SPL Could not load all domains: maximum of num reached.
num
maximum number of spooler domains to monitor previously set in ASAP.
Cause. The maximum number of spooler domains to monitor was reached.
Effect. The overflow spooler domains are not monitored.
Recovery. Monitor fewer spooler domains. If this becomes a significant issue, contact
your HP support representative.
4398
SPL Autoconfiguration completed.
Cause. No spooler domains are specified in the objective database; therefore, the
Spooler SGP has autoconfigured to monitor the $SPLS spooler.
Effect. The Spooler is configured to monitor only the $SPLS spooler.
Recovery. Informational message; no corrective action is necessary.
4399
ASAP ASAP Error #.... occurred xxxx time(s)
xxxx
is the number of times the error occurred
Cause. The error number was suppressed.
Effect. The error number suppressed had occurred xxxx times.
Recovery. None.