ASAP 3.0 Messages Manual

HP NonStop Messages Manual Page 232 of 407
Cause. The system could not get the program file name of the process. A process
went away between a GETPEEKPCBs call and a PROCESSINFO call.
Effect. The process information does not include a related program file name.
Recovery. Informational message only; no corrective action is needed.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is ―1301‖.
1302: ZASP-EVT-NO-DEVICE-NAME
Unable to get device name: err, pin#
err
indicates the outcome of a PROCESSINFO call, with either of these values:
0
indicates no error.
100
indicates that the device is not ready or that the controller is not operational.
pin#
is the process identification number.
Cause. The system could not obtain the device name of the process. The process
probably went away before the device name was obtained.
Effect. The process information does not include a related device name.
Recovery. Informational message only; no corrective action is needed.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is ―1302‖.
1303: ZASP-EVT-DELTA-TIMES
pin:ProcessTime delta:Sampletime delta in .1 sec: pin#, dpt,
dst
pin#
is the process identification number.
dpt
is the delta of the process time for this PIN.