ASAP 3.0 Messages Manual

HP NonStop Messages Manual Page 305 of 407
ZASP-TKN-ASAP-ERRORNUM is ―4393‖.
4394: ZASP-EVT-SPL-EDLLOADED-INF
SPL EDL loaded.
Cause. The Spooler EDL loaded correctly on startup of ASAP.
Effect. The Spooler SGP runs normally.
Recovery. Informational message; no corrective action is necessary.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is ―4394‖.
4395: ZASP-EVT-SPL-SAMPLESTATS-INF
SPL Sampling delay processing: num
processing
processing area for elapsed time
num
the amount of elapsed time, in milliseconds, that the specified processing took.
This is the elapsed time during processing, not the time the processing itself took.
Cause. The Spooler parameter STATS was set when the Spooler SGP was started.
Therefore, this message indicates how much time elapsed during the indicated
processing.
Effect. None.
Recovery. Informational message; no corrective action is necessary. To stop these
messages from appearing, remove the STATS parameter from the ASAPCONF file or
reset it from your ASAP session, then restart the Spooler SGP.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is ―4395‖.
4396: ZASP-EVT-SPL-RELOADPREV-INF
SPL Reloading previous configuration.