ASAP 3.0 Messages Manual

HP NonStop Messages Manual Page 306 of 407
Cause. An error occurred when trying to load the spooler domain names to monitor
(see Error! Reference source not found. on page Error! Bookmark not defined.). This
message indicates that the last list of domains will be used instead.
Effect. The previous spooler configuration is reloaded, and the last list of domains is
used.
Recovery. Informational message; no corrective action is necessary. However,
because this message appears after error Error! Reference source not found. on page
Error! Bookmark not defined., see the recovery for that message to fix the problem it
indicates.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is ―4396‖.
4397: ZASP-EVT-SPL-DOMAINOVR-INF
SPL Could not load all domains: maximum of num reached.
num
is the maximum number of spooler domains to monitor previously set in ASAP.
Cause. The maximum number of spooler domains to monitor was reached.
Effect. The overflow spooler domains are not monitored.
Recovery. Monitor fewer spooler domains. If this becomes a significant issue, contact
your HP support representative.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is ―4397‖.
4398: ZASP-EVT-SPL-AUTOCONFIG-INF
SPL Autoconfiguration completed.
Cause. No spooler domains are specified in the objective database; therefore, the
Spooler SGP has autoconfigured to monitor the $SPLS spooler.
Effect. The Spooler is configured to monitor only the $SPLS spooler.
Recovery. Informational message; no corrective action is necessary.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.