ASAP 3.0 Messages Manual

HP NonStop Messages Manual Page 316 of 407
Cause. The Tape parameter STATS was set when the Tape SGP was started. This
message indicates how many milliseconds elapsed (not how much time processing
took) when doing the indicated processing.
Effect. None.
Recovery. Informational message; no corrective action is necessary. To eliminate
these messages from appearing, remove the STATS parameter from the ASAPCONF
file or reset it from your ASAP session, and restart the Tape SGP.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is ―4495‖.
4496: ZASP-EVT-TAP-RELOADPREV-INF
TAP Reloading previous configuration.
Cause. An error occurred when trying to load the tape domain names to be monitored
(see message Error! Reference source not found. on page 307). This message
indicates that the last list of domains is used instead.
Effect. None.
Recovery. Informational message. See recovery for message Error! Reference
source not found. on page 307.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.
ZASP-TKN-ASAP-ERRORNUM is ―4496‖.
4497: ZASP-EVT-TAP-DOMAINOVR-INF
TAP Could not load all domains: maximum of num reached.
num
maximum number of tape domain entries allowed in the Tape SGP
Cause. The maximum number of tape domains to be monitored was reached.
Effect. The overflow tape domains are not monitored.
Recovery. Monitor fewer tape domains. If this becomes an issue, contact your
support representative and describe your requirements.
Data Tokens.
ZEMS-TKN-TEXT contains the message text.