ASAP 3.0 Messages Manual

HP NonStop Messages Manual Page 87 of 407
memory. If the applications were shut down, the Domain table is rebuilt over time
as they restart and register with ASAPX.
1808
Objectives load failed, domain: domain, Dmn#: domain number
Cause. ASAPX detected an error trying to load objectives for domain domain. To
determine the cause of this event, see the accompanying file-system error message.
Effect. The correct objectives are not loaded for the domain.
Recovery. Correct the file-system error and retry the operation.
1809
Registered process active: pname, Pin: pin
Cause. The application process pname was restarted before ASAPX after a processor
or system failure. ASAPX detected that it needed to rebuild the shared memory slot for
a domain but found the process that registered the domain was executing at the time.
Effect. ASAPX does not rebuild the shared memory slot for the domain because an
attempt to do so might cause MUTEX problems.
Recovery. First, stop the process in question. Second, restart ASAPX. Finally, restart
the process.
1810
Domain rebuilt from memory: domain, Dmn#: domain number
Cause. The Domain table was corrupted, possibly by entering the ASAPX CLEANUP
DOMAINS command while application processes continued to execute. ASAPX
successfully rebuilt a Domain table entry for a domain. This indicates possible
corruption of the Domain table.
Effect. ASAPX has successfully rebuilt a Domain table entry for a domain. The record
for the domain is now correct.
Recovery. No action is required. ASAPX successfully rebuilt the domain.
1811
Could not obtain process handle pname, FE: fe
Cause. ASAPX could not obtain the process handle of process pname. To determine
the cause of this problem fe, see a description of file-system error numbers.
Effect. ASAPX might report an incorrect status for a domain.