ASAP 3.0 Server Manual

HP NonStop ASAP Server Manual Page 172 of 342
value
is the stated goal for this attribute. If no value is specified, the existing value for
attribute-operator is deleted. The value must match the TypeData setting as
defined for the attribute in EDL. (See SHOW command.) For example, you
cannot set a decimal value objective for an attribute defined as an integer.
value has no meaning for the STATUS attribute.
event
INFO | CRITICAL [REPEAT] [NODISPLAY] [down] [-up]
INFO
configures ASAP to generate an informational event when the objective is
not met.
CRITICAL
configures ASAP to generate a critical event when the objective is not met.
REPEAT
causes ASAP to repeat the event for each interval where the objective is
not met.
NODISPLAY
overrides any global settings to suppress display of the event on the
operator console.
down
is the event number to use for the down event, when the objective
comparison fails. Events must be numbered in the range 6000 through
9999. Event number 4000 is used when this is not specified. The ASAP
EMS event template for the down event is not applied when custom down
events are defined.
-up
is the event number to use for the up event, which is triggered when the
objective comparison returns to normal after a failure. The number
specified must be in the range 6000 through 9999. Event number 4001 is
used when this is not specified. The minus sign must precede the up event
number even if the down event number is not specified. The ASAP EMS
event template for the up event is not applied when custom up events are
defined.