ASAP 3.1 Server Manual

HP NonStop ASAP Server Manual Page 282 of 360
*
specifies to display the performance and state information for all spoolers on the
specified system. If you do not specify a spooler or the wild-card character (*),
statistics for all spoolers on the current system are displayed.
SAMPLES count
specifies the number of sample periods to be displayed. A sample period is defined
by the RATE option in the SET command. You can specify 0 through 255 sample
periods. The default sample period number is 1.
TIME hh:mm m/d/y
defines the ending time of the display information in hours, minutes, month, day,
and year. For example, specifying ―TIME 10:15‖ when RATE is 5 indicates that
statistics collected from 10:10 to 10:15 are to be displayed.
When a ―?‖ appears immediately after the timestamp, it indicates that the statistics
are questionable and that there was a problem obtaining the statistics. Possible
reasons for questionable statistics include:
 Down disk drive or down volume
 Disk is being revived, formatted, or mounted
When a ―<‖ appears immediately after the timestamp, the statistics were received
late by the Collector process. Late statistics indicate busy Expand lines.
hh
is the hour.
mm
is the minute.
m/d/y
is the month, day, and year. Valid m/d/y entries are mm/dd/yy,
yyyy/mm/dd, or mm/dd/yyyy.
STATES
shows states associated to spooler attributes.
DETAIL
shows detailed information for the specified spooler domain (supervisor, collector,
device, print process). The specified domain name indicates which type of
information is returned (see Examples).