ASAP 3.2 Messages Manual

HP NonStop Messages Manual Page 130 of 414
4312
SPL SpoolerStatus Error= FE: error
error
error returned from the SPOOLERSTATUS or SPOOLERSTATUS2 procedure call
Cause. The NonStop Kernel SPOOLERSTATUS or SPOOLERSTATUS2 procedure
call returned the specified error. The Spooler SGP cannot handle this error.
Effect. None.
Recovery. Convert error to octal and see the Spooler manual to find out what the
error means. If it is a spooler problem, the Spooler SGP will recover once you fix the
Spooler environment. If it is not a spooler problem, contact your HP support
representative. Be ready to provide error, and create a saveabend file for the
Spooler SGP before stopping it.
4313
Error SET SPL PARAM param-error
param-error
parameter being parsed when the error occured
Cause. The specified param is not a valid parameter for the Spooler SGP.
Effect. The param is ignored.
Recovery. Verify and correct the SET SPOOLER PARAMETER that caused the
problem.
4314
SPL loc font array overflow in domain^count^jobs^locs.
Cause. The array used to temporarily hold the location entries that have an
associated device and font is full.
Effect. The FONTS attribute for devices might not be reported correctly.
Recovery. Verify the spoolers being monitored. Count the number of locations
associated with both a device and a font job. If this number is high for one spooler,
inform your HP support representative of your configuration. If this number is not high,
create a saveabend file of the Spooler SGP and contact your HP support
representative.