ASAP 3.2 Messages Manual

HP NonStop Messages Manual Page 133 of 414
Cause. The Spooler parameter STATS was set when the Spooler SGP was started.
Therefore, this message indicates how much time elapsed during the indicated
processing.
Effect. None.
Recovery. Informational message; no corrective action is necessary. To stop these
messages from appearing, remove the STATS parameter from the ASAPCONF file or
reset it from your ASAP session, then restart the Spooler SGP.
4396
SPL Reloading previous configuration.
Cause. An error occurred when trying to load the spooler domain names to monitor
(see message 4302 on page 124). This message indicates that the last list of domains
will be used instead.
Effect. The previous spooler configuration is reloaded, and the last list of domains is
used.
Recovery. Informational message; no corrective action is necessary. However,
because this message appears after error 4302 on page 124, see the recovery for that
message to fix the problem it indicates.
4397
SPL Could not load all domains: maximum of num reached.
num
maximum number of spooler domains to monitor previously set in ASAP.
Cause. The maximum number of spooler domains to monitor was reached.
Effect. The overflow spooler domains are not monitored.
Recovery. Monitor fewer spooler domains. If this becomes a significant issue, contact
your HP support representative.
4398
SPL Autoconfiguration completed.
Cause. No spooler domains are specified in the objective database; therefore, the
Spooler SGP has autoconfigured to monitor the $SPLS spooler.
Effect. The Spooler is configured to monitor only the $SPLS spooler.
Recovery. Informational message; no corrective action is necessary.