ASAP 3.2 Messages Manual

HP NonStop Messages Manual Page 141 of 414
num
elapsed time spent in the processing area
Cause. The Tape parameter STATS was set when the Tape SGP was started. This
message indicates how many milliseconds have elapsed (not how much time
processing took) when doing the indicated processing.
Effect. None.
Recovery. Informational message; no corrective action is necessary. To prevent
these messages from appearing, remove the STATS parameter from the ASAPCONF
file or reset it from your ASAP session, and restart the Tape SGP.
4496
TAP Reloading previous configuration.
Cause. An error occurred when trying to load the tape domain names to be monitored
(see message 4402 on page 132). This message indicates that the last list of domains
is used instead.
Effect. None.
Recovery. Informational message. See recovery for message 4402 on page 132.
4497
TAP Could not load all domains: maximum of num reached.
num
maximum number of tape domain entries allowed in the Tape SGP
Cause. The maximum number of tape domains to be monitored was reached.
Effect. The overflow tape domains are not monitored.
Recovery. Monitor fewer tape domains. If this becomes an issue, contact your
support representative and provide your requirements.
4498
TAP Autoconfiguration completed.
Cause. No tape domains are specified in the objective database, so the Tape SGP
autoconfigured to monitor all tape devices found on the system.
Effect. None.
Recovery. Informational message; no corrective action is necessary.