ASAP 3.2 Messages Manual

HP NonStop Messages Manual Page 45 of 414
1024
$RECEIVE read, FE: err
err
is the file-system error number associated with the last operation on the file.
Cause. A system message was not received or read.
Effect. The system did not receive the message.
Recovery. The FILEINFO system call returned this error. For corrective action for the
specified error code, see the Operator Messages Manual or the Guardian Procedure
Errors and Messages Manual .
Retry your operation, but this time pause for awhile between commands. For example,
the system need a momentary pause if it cannot process a shutdown command
immediately after a startup command.
1025
$RECEIVE reply failed, FE: err
err
is the file-system error number associated with the last operation on the file.
Cause. The system could not reply to a message it received from a READUPDATE(X)
call on the $RECEIVE file.
Effect. The system did not reply to the message.
Recovery. The FILEINFO system call returned this error. For corrective action for the
specified error code, see the Operator Messages Manual, or the Guardian Procedure
Errors and Messages Manual .
If the problem persists, contact your HP representative.
1026
Sample Missed. SecsSinceLast>RateSecs sec,rate
sec
is the number of seconds expired while trying to write to the collector.
rate
is the sample rate configured less 20 percent.
Cause. The ASAP collector process is experiencing queueing problems.