ASAP 3.2 Messages Manual

HP NonStop Messages Manual Page 56 of 414
err
is one of these SPI error numbers:
0
Indicates there is no error
-1
Indicates an invalid buffer format
-2
Indicates an invalid parameter value
-3
Indicates a missing parameter
-4
Indicates an invalid parameter address
-5
Indicates the buffer is full
-6
Indicates an invalid checksum
-7
Indicates an internal error
-8
Indicates the list token was not found
-9
Indicates an invalid token code or map
-10
Indicates an invalid subsystem ID
-11
Indicates the operation is not supported
-12
Indicates insufficient stack space
Cause. The Expand SGP could not build a Subsystem Programmatic Interface (SPI)
request buffer.
Effect. No information was returned by SPI.
Recovery. Check the NonStop operating system version to make sure all the SPI
routines are installed. These routines include SSPUT, SSGET, SSINIT, and others.
Retry the request. If the problem persists, contact your HP representative.
1232
Monitor -> ExpMgr ($ZEXP) FS Error: err
err
is the file-system error number associated with the last operation on the file.
Cause. A file-system error occurred in communication between the Expand SGP and
the Expand Manager.
Effect. Subsystem Programmatic Interface (SPI) requests could not be written to the
Expand Manager.
Recovery. The FILEINFO system call returned this error. For corrective action for the
specified error code, see the Operator Messages Manual or the Guardian Procedure
Errors and Messages Manual .
Check that the Expand Manager is up and running. If the problem persists, contact
your HP representative.