ASAP 3.2 Messages Manual

HP NonStop Messages Manual Page 68 of 414
dpt2
is the last word of the process delta for this PIN.
Cause. ASAP detected a 100 percent PCB busy, possibly because of a NonStop
operating system internal interface failure.
Effect. The PCB busy information is suspect.
Recovery. If the problem persists, contact your HP representative.
1305
Pin:This_ProcessTime:Last_ProcessTime in 10 sec: pin#, pt1,
pt2
pin#
is the PIN number of the process.
pt1
is the total process time of this PIN at the current sample time.
pt2
is the total process time of this PIN at the last sample time.
Cause. ASAP detected a 100 percent PCB busy, possibly because of an internal
NonStop operating system interface failure.
Effect. The PCB busy information in the sample might be distorted.
Recovery. If the problem persists, contact your HP representative.
1306
Pin:Alive but No PCB:priority:Last_PTime in .1 sec: pin#, pri,
pt2
pin#
is the PIN number of the process.
pri
is the process priority.
pt2
is the total process time of this PIN at the last sample time.