ASAP 3.2 Messages Manual

HP NonStop Messages Manual Page 75 of 414
1703
ASAPDSK ASAPmeas file in use err
err
is the Measure error returned from the Measure subsystem
Cause. The Measure subsystem has a measurement data file with the same name as
ZASPxxx, where xxx is the ASAP ID. The DISK SGP could not delete it.
Effect. ASAPDSK cannot obtain disk counters. Disk device status information is valid
when ASAPDSK cannot obtain the disk counters.
Recovery. Close the file through MEASCOM. The disk SGP will attempt to start the
measurement during the next sample period. You can also use the ASAP
Conversational Interface (CI) and specify another volume, subvolume, or both. Once
you specify another location, restart the ASAP Monitor. An example of the ASAP CI
command is:
SET ASAPDSK on,PARAM "$vol.subvol"
1704
Set Disk param VOLUME/SUBVOL to another location
Cause. The Measure subsystem has a measurement data file with the same name as
ZASPxxx, where xxx is the ASAP ID. The disk SGP could not delete it.
Effect. ASAPDSK cannot obtain disk counters. Disk device status information is valid
when ASAPDSK cannot obtain the disk counters.
Recovery. Use the ASAP Conversational Interface (CI) to set ASAPDSK with a
different volume or subvolume than was previously specified. If you used the default,
try a volume other than $SYSTEM.
1705
ASAPDSK MEASFH Trapped err
err
is the Measure error returned from the Measure subsystem
Cause. The MEASFH process has trapped out.
Effect. ASAPDSK cannot obtain disk counters. Even though disk utilization samples
cannot be made, the disk device status information is still valid.