ASAP 3.2 Messages Manual

HP NonStop Messages Manual Page 78 of 414
Recovery. Specify a different CPU for the MEASFH process by using the ASAP
Conversational Interface (CI) to specify CPU cpu-number in the SET DISK command.
Next, restart the ASAP Monitor. An example of the CI command is:
SET DISK ON, PARAM "CPU 3"
1712
ASAPDSK Measctl Resources Exceeded err
err
is the Measure error returned from the Measure subsystem
Cause. ASAPDSK could not start a measurement because the MEASCTL process
reached its maximum resources.
Effect. ASAPDSK cannot obtain disk counters. Disk device status information is valid
when ASAPDSK cannot obtain the disk counters.
Recovery. If possible, stop and delete unnecessary measurements. Restart the ASAP
Monitor once the Measure subsystem has fewer than 64 measurements configured.
1713
ASAPDSK Measctl Counter Allocation error err
err
is the Measure error returned from the Measure subsystem
Cause. ASAPDSK could not start a measurement because the MEASCTL process
reaches its maximum internal counter space.
Effect. ASAPDSK cannot obtain disk counters. Disk device status information is valid
when ASAPDSK cannot obtain the disk counters.
Recovery. If possible, stop and delete unnecessary measurements. Restart the ASAP
Monitor once the Measure subsystem has fewer than 64 measurements configured.
1715
ASAPDSK Error SET DISK PARAM CPU nn cpu
cpu
is the CPU number selected
Cause. The Disk SGP could not start a measurement in the specified CPU.