Asynchronous Terminals and Printer Processes Configuration and Management Manual

What’s New in This Manual
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
viii
New and Changed Information
•
Section 3, Configuring the ATP6100 Subsystem
•
HIGHPIN OFF on page 4-17
•
NOLINE1FORMF on page 4-19
•
NORC on page 4-19
•
NOVFU72LINES on page 4-21
•
SPACINGPOST on page 4-23
•
HIGHPIN OFF on page 5-22
°
Command Syntax for the ABORT LINE Command on page 6-8
°
Command Syntax for the ABORT SU Command on page 6-9
°
Command Syntax for the ACTIVATE SU Command on page 6-10
°
Command Syntax for the ALTER LINE Command on page 6-11
°
Command Syntax for the ALTER SU Command on page 6-12
°
Command Syntax for the INFO LINE Command on page 6-14
°
Command Syntax for the INFO SU Command on page 6-16
°
Command Syntax for the LOAD LINE Command on page 6-19
°
Command Syntax for the START LINE Command on page 6-20
°
Command Syntax of the START SU Command on page 6-21
°
Command Syntax for the STATS LINE Command on page 6-22
°
Command Syntax for the STATS SU Command on page 6-25
°
Command Syntax of the STATUS LINE Command on page 6-28
°
Command Syntax for the STATUS SU Command on page 6-32
°
Command Syntax for the STOP LINE Command on page 6-34
°
Command Syntax for the STOP SU Command on page 6-35
°
Command Syntax for the SUSPEND SU Command on page 6-36
°
Command Syntax for the SWITCH PROC Command on page 6-37
°
Command Syntax for the TRACE LINE Command on page 6-38
•
Appendix A, ATP6100 Subsystem Error Messages
•
Appendix C, Moving to G-Series or H-Series RVUs
•
Glossary
Note. The following command syntax changes are only related to introducing a new manual
(SCF Reference Manual for H-Series RVUs).