Asynchronous Terminals and Printer Processes Configuration and Management Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Configuration Quick Start
- 2 Overview of the ATP6100 Subsystem
- 3 Configuring the ATP6100 Subsystem
- 4 Printer Profiles and Default Modifiers
- 5 Terminal Profiles and Default Modifiers
- 6 ManagingATP6100Usingthe SubsystemControlFacility(SCF)
- 7 PTrace Facility for ATP6100
- A ATP6100 Subsystem Error Messages
- B SCF Command Summary for ATP6100
- ABORT LINE Command
- ABORT SU Command
- ACTIVATE SU Command
- ALTER LINE Command
- ALTER SU Command
- INFO LINE Command
- INFO SU Command
- LOAD LINE Command
- START LINE Command
- START SU Command
- STATS LINE Command
- STATS SU Command
- STATUS LINE Command
- STATUS SU Command
- STOP LINE Command
- STOP SU Command
- SUSPEND SU Command
- SWITCH PROC Command
- TRACE LINE Command
- VERSION PROC Command
- C Moving to G-Series or H-Series RVUs
- Glossary
- Index
Managing ATP6100 Using the
Subsystem Control Facility (SCF)
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
6-15
INFO LINE Command
Display of the INFO LINE Command
The format of the display for LINE object without the DETAIL option is shown below.
Alterable modifiers are denoted with an asterisk. Refer to Section 4, Printer Profiles
and Default Modifiers, and Section 5, Terminal Profiles and Default Modifiers. for
detailed descriptions of these modifiers.
Display of the INFO LINE Command With DETAIL
The format of the display for LINE object with the DETAIL option is shown below.
Alterable modifiers are denoted with an asterisk. Refer to Section 4, Printer Profiles
and Default Modifiers, and Section 5, Terminal Profiles and Default Modifiers. for
detailed descriptions of these modifiers.
Program
Indicates the CLIP download program file.
Opclass
Indicates the Operation class of the line. This should be ASYNC or ANY.
Protocolid
Indicates the CLIP protocol ID.
Type
Indicates the type and subtype of the device.
Consideration for the INFO LINE Command
•
The SUB and DETAIL options are supported.
ATP6100 INFO LINE
Name Opclass *Program
$ATPS1 ASYNC $SYSTEM.CSSnn.C1094P00
$ATPS1 ASYNC $SYSTEM.CSSnn.C7948P00
ATP6100 Detail INFO LINE $ATPS1
Opclass...................ASYNC
*Program..................$SYSTEM.CSSnn.C1094P00
Type......................(53,1) Protocolid..........3