Asynchronous Terminals and Printer Processes Configuration and Management Manual

Managing ATP6100 Using the
Subsystem Control Facility (SCF)
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
6-19
LOAD LINE Command
LOAD LINE Command
The LOAD LINE command downloads the Data Link Control (DLC) task to the
SWAN/SWAN 2 concentrator. LOAD LINE is a sensitive command.
Command Syntax for the LOAD LINE Command
The LOAD LINE command has the following syntax:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
LINE line-name
designates the line to be downloaded. If you omit line-name, the assumed line
is aborted (see the SCF Reference Manual for G-Series RVUs or SCF Reference
Manual for H-Series RVUs for details about the ASSUME command).
Considerations for the LOAD LINE Command
•
The SUB and SEL options are not supported.
•
The LOAD LINE command is valid only if the line is in the STOPPED state.
•
Line loaded means the clip code is downloaded.
Examples of the LOAD LINE Command
The following SCF command loads line $ATPS1.
->LOAD LINE $ATPS1
LOAD [ /OUT file-spec / ] LINE line-name