Asynchronous Terminals and Printer Processes Configuration and Management Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Configuration Quick Start
- 2 Overview of the ATP6100 Subsystem
- 3 Configuring the ATP6100 Subsystem
- 4 Printer Profiles and Default Modifiers
- 5 Terminal Profiles and Default Modifiers
- 6 ManagingATP6100Usingthe SubsystemControlFacility(SCF)
- 7 PTrace Facility for ATP6100
- A ATP6100 Subsystem Error Messages
- B SCF Command Summary for ATP6100
- ABORT LINE Command
- ABORT SU Command
- ACTIVATE SU Command
- ALTER LINE Command
- ALTER SU Command
- INFO LINE Command
- INFO SU Command
- LOAD LINE Command
- START LINE Command
- START SU Command
- STATS LINE Command
- STATS SU Command
- STATUS LINE Command
- STATUS SU Command
- STOP LINE Command
- STOP SU Command
- SUSPEND SU Command
- SWITCH PROC Command
- TRACE LINE Command
- VERSION PROC Command
- C Moving to G-Series or H-Series RVUs
- Glossary
- Index
ATP6100 Subsystem Error Messages
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
A-2
About ATP6100 Errors
About ATP6100 Errors
Each error listed includes a description of the probable cause of the error condition, an
explanation of the effect of the error, and a recommended recovery action. Error
messages are listed in numerical order.
The user can receive error messages through SCF. The messages are generated by
the file system, Subsystem Control Point (SCP), and so on. File-system, SCP, and
other errors originating outside the SCF environment are described in the
documentation supporting the particular source of the error and are not listed in this
manual. For information about trace-related errors, see the PTrace Reference Manual.
Some ATP6100 error messages are not easily recoverable and require you to seek
additional help. In these cases, you should follow the standard procedures at your site
for contacting the appropriate support personnel. These procedures might involve
contacting support representative.
Before contacting your support representative, it is recommended that you collect any
relevant information (including the details from the error message), supporting
documentation (such as Event Management Service [EMS] logs), and a description of
the problem and the accompanying symptoms, so that you can provide the data to
support personnel. If your local operating procedures require contacting the TNSC,
please supply your system name and the numbers on versions of all related products
as well.
ATP6100 Error 00510
Cause. The STOP command failed because the SU is opened. The subdevice cannot
be stopped when the subdevice is opened.
Effect. The STOP command is not executed.
Recovery. Close the subdevice and execute the STOP command, or use the ABORT
command.
ATP6100 Error 00511
Cause. The modifier value is not within range for the given modifier.
Effect. The specified modifier is not altered.
Recovery. Give the correct value for the modifier and execute the command again.
ATP6100 00510 name is in use.
ATP6100 00511 Command rejected because of invalid attribute
value.