Asynchronous Terminals and Printer Processes Configuration and Management Manual

ATP6100 Subsystem Error Messages
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
A-3
About ATP6100 Errors
ATP6100 Error 00512
Cause. The START command was rejected due to an inconsistent baud rate and
interface to the SU, or inconsistent SU baud rate and LINE controller type, or
inconsistent SU interface and LINE controller type.
Effect. The START command is not executed.
Recovery. Alter the baud rate and interface to the consistent values, and execute the
START command again.
ATP6100 Error 00513
Cause. The START SU command was rejected because the LINE is not in the
STARTED state.
Effect. The specified SU is not started.
Recovery. Start the line and then START the SU.
ATP6100 Error 00514
Cause. The ALTER SU command was rejected because the given modifier is not valid
for the current TYPE and SUBTYPE of the line.
Effect. The ALTER SU command is not performed.
Recovery. Use the valid modifier for the current TYPE and SUBTYPE of the line.
ATP6100 Error 00515
Cause. The TRACE BACKUP command was rejected because the current process is
not the primary or the backup process does not exist or is unable to communicate with
the backup process.
Effect. The TRACE BACKUP command is not executed.
Recovery. Verify that if the backup CPU is up. If it is not up, reload the CPU.
ATP6100 00512 START command rejected because of invalid
combination of baudrate, interface, and controller type.
ATP6100 00513 name not started because line is not in started
state.
ATP6100 00514 Alter SU rejected because given attribute is
not valid for the current TYPE of the line.
ATP6100 00515 Backup Process does not exist or unable to
communicate with the Backup Process.