Asynchronous Terminals and Printer Processes Configuration and Management Manual

Moving to G-Series or H-Series RVUs
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
C-2
SYSGEN-to-SCF Considerations
You use the SCF interface to the WAN subsystem to perform these functions. The
WAN subsystem and the SCF interface to the WAN subsystem are described in detail
in the WAN Subsystem Configuration and Management Manual.
SYSGEN-to-SCF Considerations
The System Generation (SYSGEN) program is not used for G-series or H-series
RVUs. This subsection explains how information that is configured in SYSGEN
CONFTEXT paragraphs on D-series systems is defined on G-series or H-series RVUs.
CONFTEXT Paragraph Information
Table C-1 lists the CONFTEXT paragraphs that are relevant to ATP6100 configuration
and how the information in each paragraph is defined on G-series and H-series RVUs.
For more information about WAN subsystem configuration, see the WAN Subsystem
Configuration and Management Manual. For more information about NonStop Kernel
subsystem configuration, see the SCF Reference Manual for the Kernel Subsystem.
Macro-Profile Comparison
For D-series systems, default values for ATP6100 line types are contained in SYSGEN
macros. For G-series and H-series RVUs, profiles are used in a similar way as shown
in the following table.
Table C-1. Defining CONFTEXT Paragraph Information on G-Series or H-series
RVUs
CONFTEXT Paragraph G-Series or H-series Definition
DEFINES Customizes a profile to be used later when configuring
a DEVICE object type
CONTROLLERS Concentrator information is configured through the
WAN subsystem
PATHS Not applicable for G-series or H-series RVUs
PERIPHERALS IOPs are configured through the WAN subsystem
ALLPROCESSORS Still exists in G-series or H-series CONFTEXT file
Table C-2. ATP6100 Macro and Profile Correlations (page 1 of 2)
D-Series Macros G-Series or H-series Profiles
5512 PATP5512
5515 PATP5515
5516 PATP5516
5520 PATP5520
5530 PATP5530