Asynchronous Terminals and Printer Processes Configuration and Management Manual

Moving to G-Series or H-Series RVUs
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
C-3
COUP-to-SCF Considerations
For more information on creating profiles, see the WAN Subsystem Configuration and
Management Manual.
COUP-to-SCF Considerations
The COUP interface is not supported for G-series or H-series RVUs. COUP
functionality is replaced by SCF. Although most COUP commands have a direct SCF
equivalent, the method for configuring G-series and H-series RVUs is very different
from D-series systems. Refer to the SCF reference manuals listed in About This
Manual for more information.
The following COUP commands have no SCF equivalent and cannot be used with G-
series systems:
5540 PATP5540
5573 PATP5573
5577 PATP5577
ASYNC_PRT PATPPRT
6401 PATP6401
6402 PATP6402
6511 PATP6511
6512 PATP6512
6520 PATP6520
6524 PATP6524
6530 PATP6530
6603 PATP6603
6604 PATP6604
ASYNC_TERM PATPTERM
CONFIG
INFO CONTROLLER
INFO MF_CONTROLLERS
INFO PATH
RESET
SHOW
TIME
Table C-2. ATP6100 Macro and Profile Correlations (page 2 of 2)
D-Series Macros G-Series or H-series Profiles